Xin Xin teach you how to use the proximity switch

Updated: 2016-1-20

Injection Molding Machine * Note * The following contents are essential to ensure safe use. 1. Do not use in flammable, volatile, explosive gas environment; Do not carry on any decomposition, repair, modification and so on to this product. 2. The power supply voltage: Do not exceed the specified voltage, if the use of more than the voltage specified voltage or can only use the DC power supply products can cause AC products to burst, burned. 3. Short-circuit on the load side: Do not short-circuit the load side. Do not terminate the load on the power supply. Otherwise it will cause the product to burst, burned. 4. Wiring: Do not make mistakes such as incorrect power polarity, incorrect wiring, etc., otherwise it will cause the product to burst and burn. 5. Wiring without load: If the power is not connected to the load, there is a risk of component rupture and burnout. * Precautions before use * Be sure to contact the sales person in addition to the specifications, function margin, or fail-safe conditions when using the environment under the following conditions: 1. In the conditions, environment not described in the operating instructions . 2. For nuclear control, railway, aviation, vehicles, burning devices, entertainment equipment, medical equipment, safety equipment. 3 is expected to have a greater impact on life and property, especially for safety requirements of the occasion. * Proper use of the method * 1. Do not use in the following places: a Outdoor (such as direct sunlight, rain, snow, water droplets and other direct contact with the place) b chemicals, especially in solvents, acid steam environment c corrosive gases 2. When the proximity switch is used near a mobile phone, a transceiver, or the like, it is necessary to pay attention to the malfunction of the proximity switch. 3.When mixed with high-voltage line and power line in the same wiring tube or slot wiring, it may cause malfunction or damage due to induction. Please separate or separate wiring. 4. For cleaning: thinner will cause the product surface melting, so do not use. 5. Fixing: Set the tightening torque of the fixing screw to less than 0.5Nm 6. The influence of the surrounding metal: When there is metal around it, it will be affected by the production and so on. If it does not produce bad reversion, Metal, with the temperature changes affect the detection distance change. Note the minimum distance shown in Table (1). The actual distance must be greater than this minimum distance. 7. Mutual interference: When there are multiple proximity switches used together, due to mutual interference may be the possibility of malfunction, greater than the range shown above the range of use. Used injection molding machine